Close Alternative — 72.8% match
based on chemical composition and mechanical property overlap.
EN 10088-1 1.4301 (EN 10088-1:2014) and GOST 5632 08X18H10 (GOST 5632-2014) are both steel grades.
Both fall under the Stainless Steel category.
EN 10088-1 1.4301 is typically used for food equipment, chemical vessels, architectural, kitchenware, while GOST 5632 08X18H10 is commonly used for chemical equipment, food processing, general corrosion resistant applications.
EN 10088-1 1.4301 is defined under European Standard (EN) (Europe).
As per chemical composition, EN 10088-1 1.4301 vs GOST 5632 08X18H10 is a 92.5% match.
As per mechanical properties, the match is 33.3%.
Combined, this makes them a close alternative overall at 72.8%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
EN 10088-1 1.4301
GOST 5632 08X18H10
Tensile Strength
≥520 MPa
≥520 MPa
Yield Strength
≥210 MPa
≥205 MPa
Elongation
≥45%
≥40%
Hardness
≤215 HB
Not specified
Typical Applications
EN 10088-1 1.4301
Food equipment, chemical vessels, architectural, kitchenware
GOST 5632 08X18H10
Chemical equipment, food processing, general corrosion resistant applications
Can EN 10088-1 1.4301 Be Substituted With GOST 5632 08X18H10?
EN 10088-1 1.4301 and GOST 5632 08X18H10 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.
What is the difference between EN 10088-1 1.4301 and GOST 5632 08X18H10?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can EN 10088-1 1.4301 be substituted with GOST 5632 08X18H10?
EN 10088-1 1.4301 and GOST 5632 08X18H10 are a close alternative rather than a direct substitute. Some properties overlap well, but check the specific chemistry and mechanical rows above against your application's requirements before treating them as interchangeable.