Minimal Match — 35% match
based on chemical composition and mechanical property overlap.
IS 5522 X07Cr17 (IS 5522:2014) and EN 10088-1 1.4301 (EN 10088-1:2014) are both steel grades.
Both fall under the Stainless Steel category.
IS 5522 X07Cr17 is typically used for utensils, while EN 10088-1 1.4301 is commonly used for food equipment, chemical vessels, architectural, kitchenware.
IS 5522 X07Cr17 is defined under Bureau of Indian Standards (IS), originating from India, while EN 10088-1 1.4301 is defined under European Standard (EN), originating from Europe.
As per chemical composition, IS 5522 X07Cr17 vs EN 10088-1 1.4301 is a 67.4% match.
As per mechanical properties, the match is 0%.
Combined, this makes them a minimal match overall at 35%.
Matched by chemical composition and mechanical properties, not a formal equivalence claim. Always verify against the applicable standard before substitution.
Mechanical Properties
Property
IS 5522 X07Cr17
EN 10088-1 1.4301
Tensile Strength
>=450 MPa
≥520 MPa
Yield Strength
>=205 MPa
≥210 MPa
Elongation
>=20%
≥45%
Hardness
<=183 HB
≤215 HB
Condition
Annealed/softened
Not specified
Typical Applications
IS 5522 X07Cr17
Utensils
EN 10088-1 1.4301
Food equipment, chemical vessels, architectural, kitchenware
Can IS 5522 X07Cr17 Be Substituted With EN 10088-1 1.4301?
IS 5522 X07Cr17 and EN 10088-1 1.4301 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.
What is the difference between IS 5522 X07Cr17 and EN 10088-1 1.4301?
Both grades share a similar composition profile; see the specification table above for the exact chemistry and mechanical property values.
Can IS 5522 X07Cr17 be substituted with EN 10088-1 1.4301?
IS 5522 X07Cr17 and EN 10088-1 1.4301 share some compositional similarity but differ enough that substitution should not be assumed. Review the differences above carefully, and consult the applicable standard or a metallurgist before using one in place of the other.